Product Materials
COVER: ¼” (6 mm) thick one-piece cast iron with white porcelain enameled coating. Cover fixed to the base plate with two vandal-resistant lock screws and lock with special key wrench.
NOZZLE: chrome-plated zamak. Nozzle is fixed.
MOTOR: universal-type protected by a 4-amp fuse with sealed self-lubricated ball bearings. Aluminum centrifugal turbine with double symmetrical inlet. Fireproof plastic UL 94-VO scroll fan.
HEATING ELEMENT: undulated nicrom with a safety thermostat.
ELECTRONIC CONTROL: electronic infrared detection sensor is adjustable (6″–10″). Switch-off delay is two seconds maximum.
Models 2903-28 have a proximity sensor mounted to the cover near the air outlet with a wire clipped to the base. Before completely removing the cover, the wire must be unclipped from the base.
BASE PLATE: 1 ⁄8″ (3 mm) thick aluminum, with four Ø 5 ⁄16″ (8mm) holes for wall mounting.
Installation: Verify all rough-in dimensions prior to installation. Hand dryers require a dedicated circuit and must be properly grounded. GFI Circuit protection is recommended. One side of dryer should be mounted to a stud.
Operation: Place hands 3″−6″ below nozzle to activate air flow. Dryer will stop two seconds after hands are removed from air flow.
Warranty:
- Sensors – one (1) year
- Motor Brushes – three (3) years
- All Other Components – ten (10) years.
